New answers tagged arduino-nano
0
votes
Use of 3 synchronized PWM pins on Arduino Nano
You can generate three synchronized 10 kHz PWM signals on an Arduino Nano. The Nano uses an ATmega328P, which has only two Timer1 channels. So, hardware PWM alone cannot give three synced outputs. The ...
- 61
2
votes
Accepted
Software serial and RS485
TL;DR: The statement that "other libraries (and to extend, any other interrupt-driven software, for example your own) can potentially interfere with SoftwareSerial" is correct.
In your ...
- 2,466
2
votes
6 wire 3 digits 7 segment display and arduino question
yes, that's CharliePlexing, Some kind if multiplexing without IC, As far as I understood it is based on Base3 instead of Base2 for On&Off. It is based on Base3 for High,Low,Disconnected logic
2
votes
Arduino Nano not showing up in /dev
Just had this issue with a Nano 33 IoT , double clicking "Reset" seems to solve it.
When connecting, the Nano "On" LED lights up, but nothing shows in dmesg -w or lsusb. The cable ...
- 121
1
vote
Missing data when communicating over UART
There are a couple of issues here:
while (Serial0.available() > 0) {
response[index++] = Serial0.read();
timeout = millis() + 1000;
}
First, the variable timeout is updated, but its value is ...
- 45.2k
Top 50 recent answers are included